2. analog
  3. 119660-74046

Advice for a new Oracle Delphi Owner

Calling all Oracle Delphi owners, I recently bought a nice condition MK III and have a couple of questions for existing or previous owners of this fine turntable.

My questions are.

1) Do you always switch off the platter each time you change the record over or try to unclamp, flip over, re clamp whilst the platter is spinning. If the answer is yes I assume the motor is robust enough for the constant switching on and off?

2) Do you ever play with an alternative platter mat without the clamp. If so what brand.

I really like this turntable and it sounds excellent with no issues evident at the moment. My only thoughts are that it is a little more time consuming to use due to the constant power off, unclamp, place record, reclamp, power on and play routine for every side of play. 

Look forward to any input.

Thanks.
ateal
ateal OP
95 posts
 
Hi Harold, with regards to the suspension tuning / balancing is there anything other than ensuring the distance between the plinth and the underside of the suspension housing on each pillar is equal to the "B" point of the suspension gauge (21mm). And also making sure the correct spring is used in each location.

Is there a further check that needs to be done. I heard there was a bounce check but i don’t know what that is. What would you advise to ensure perfect suspension tuning.

Also what are the effects on either side of the ideal setting. Does the bass get flabby with looser suspension or does the treble rise with a stiffer setting.

Any observations you may have would be most welcome.

Thanks
Ag insider logo xs@2x
cleeds
2,065 posts
 
ateal OP" ...with regards to the suspension tuning / balancing is there anything other than ensuring the distance between the plinth and the underside of the suspension housing on each pillar is equal to the "B" point of the suspension gauge (21mm). And also making sure the correct spring is used in each location.

Is there a further check that needs to be done."

Yes. When excited - tap on the platter vertically - the platter assembly should vibrate in a purely vertical, pistonic manner, with no wobbling from side-to-side. If it wobbles, either the tower heights are not properly adjusted, and/or one or more springs must be twisted (without changing height) so that the ends of the coil of each of the three springs share the same orientation.
ateal OP
95 posts
 
Hi Cleeds, that's easy, I'm always excited when playing vinyl:). On a serious note though, thanks for that info, I will perform the test tonight and make any necessary adjustments as per your advice.

 
ateal OP
95 posts
 
After getting great advice here, I went home and did the bounce test. I gave it a little tap on the top of the clamp and watched the bounce. The results seemed good - the bounce remained completely vertical just like a piston, I didn't notice any lateral movement. The actual bounce from a single light tap seemed to go on for at least 15 to 20 cycles which seemed higher than I have read elsewhere on the web. Not sure if that is too much bounce? 

Also the bounce came to a gentle stop with very tiny movement towards the end. This indicates to me that there is nothing hindering the bounce.

Any comments from current or previous owners more than welcome.

harold-not-the-barrel
799 posts
 
Excellent ! No lateral movement. The sound is already there. There is never too much bounce. It was so fun to bounce my Delphis. I dreamed the bouncing would last for a minute, at least. Seriously, happy days :)
More to discover