Amplifier Weight. A Factor?


With majority of the good high-end amplifiers exceeding 100lb, it is actually painful to move them. So, here are questions to all.
Is amplifier’s weight a factor in your amplifier selection?
If you own heavy weight amps (i.e. Krell FPB600/180lb, Levinson 33/365 lb), how do you handle them without scratch?

Ldk
ldk
I think it was audio magazine years ago that provided a watts per pound per dollar assessment of amplifiers. It was all tongue in cheek but I bet it would support your conclusions. Are the best guitars the heaviest as well?
A guitar doesn't have a power supply. Electronic components have power supplies and the power supplies are a lot more influential in the performance of components that most realize. Of course, you have a lot of manufacturers making components and using crappy, cheap, light weight power supplies that will try and tell you otherwise, but of course their components don't typically stack up very well.
Weight seems a deciding factor with tube amps, as others have said. There is simply no substitute for big, high quality output transformers with tube amps. If a tube amp does'nt weigh 50lbs+, it will not have the base to give long term satisfaction.
Before anyone else says it, this does'nt apply to OTL amps, though they seem pretty heavy too. I bought a little!! Ayon Spark tube amp recently, it looks small, but it is a brute to move, with all the weight in 3 massive transformers in the back. Was it worth the prolapsed disc getting it upstairs? Absolutely
The weight of amplifier, largely, depends on its power supplies. Many look on rms power in specs to estimate how powerful the amplifier in question is but others look only at headroom i.e. peak voltage, current, their duration and level of distortions there.

In that regard, all amplifiers of all types (A,B,D tube, ss etc) will in the future benefit from ultralight weight FULLY REGULATED and LOW NOISE switching power supplies.

Today,as far as I know, only Jeff Rowland in their flagship amplifiers and Spectron in their pro audio amplifiers use this technology (again FULLY REGULATED and LOW NOISE). For illustration, Spectron (prototype) pro audio 8000 watts rms amplifier weight about 100 lbs.

Simon
I think unsound said it best. My Burson's casework is the heatsink so its a little heavier than its size would indicate but not by much compared to others.