There is no formula to convert static compliance to dynamic. In fact dynamic cu can be different laterally than vertically. For resonance estimates vertical is normally used. Most specs are dynamic cu. For example, most Benz carts are 15cu (dynamic). VDH only gives static, but tells you eff mass range of arms for the cartridge.
The only examples of both static and dynamic I could find listed is AT. The 33EV has a static cu of 40. Dynamic is 10 @100Hz. That's equivalent to approx 17, 18 @10Hz. There is no reliable formula to convert 100Hz to 10Hz.
www.lpgear.com/product/AT33EV.html
IMO it's better to find out what makes a good match from other users. Resonance estimates are often wrong and great sounding combos can be outside of the recommended range. If you want to find out exactly what res freq is, get a test record. You're more likely to get bad results with a low cu cart on a light arm. When res is near the audible band it can impact on the music.
Regards,
The only examples of both static and dynamic I could find listed is AT. The 33EV has a static cu of 40. Dynamic is 10 @100Hz. That's equivalent to approx 17, 18 @10Hz. There is no reliable formula to convert 100Hz to 10Hz.
www.lpgear.com/product/AT33EV.html
IMO it's better to find out what makes a good match from other users. Resonance estimates are often wrong and great sounding combos can be outside of the recommended range. If you want to find out exactly what res freq is, get a test record. You're more likely to get bad results with a low cu cart on a light arm. When res is near the audible band it can impact on the music.
Regards,