Graham Phantom damping fluid level.


Bob Graham says to use enough fluid to bring the level up to the top of the square profile machined on the bearing cap. The square is only about 1/4" in length. My question is, What level works best for you in relationship to this "square" profile?

I have tried only 3 different levels of fluid in my setup (maximum level to top of square, almost no fluid at all, & to the bottom of the square) but can't seem to obtain optimum results so I'm wondering what others use, although I guess it's really cartridge dependent. Is the fluid level super sensitive? FWIW I'm using a Koetsu RSP.
frank_sm
thanks for the response Hevac. I appreciate you reaching out. I hope Bob Graham gets well soon.
I apply the fluid as recommended. If the sound is a bit dull, I use a syringe with an 18 gauge needle to remove a little bit; wait several hours, and repeat until it sounds right. It is not precise, but I wouldn't obsess on the fluid level. There has to be a point that we enjoy listening to the darn thing.

Congratulations to Sirspeedy on the aquisition of his new tonearm.
Sirspeedy thanks for the reply.
The Denon Telarc Omni-disk is the one I use to set anti skating.
I know the distrtion will start somewhere in the track I am just trying to get them even close to distorting at the same time. Now the they are not even close maybe 5 seconds between both channels.
Thanks for the help.
Sirspeedy you don't live in Mass. do you?