Hafler DH300 Monoblock forever?

Take a look at the twisted wire pairs from the input jacks. If they are each connected directly to terminals 1 & 2 of both PC-6 boards, you should be good to go(in stereo). If it's bridged for mono operation; only the left input will be connected, and the two positive speaker terminals will be the output.

Yes, both inputs are going right up to pins 1&2 on the PC6 boards. If I convert back to regular phono jacks on the inputs I imagine there must have been some good reason for the 2.2 ohm resistor on the right input jack of my similar DH-200, between it's (-) and ground...? There isn't one on the left channel, nor was there supposed to be at least looking at my original wiring diagram. Thanks for all your help!

You are correct, concerning the 2.2ohm resistor(R45/pn 133022). There was only one provided, in the kit. The DH-200 schematic shows that on the ground of the left input. Given the age of your amps(30yrs+), you might consider obtaining some new power supply filter caps. Though yours may still work; I promise you will notice a marked difference in performance, with new ones. ( http://www.digikey.com/product-detail/en/CGS103U075V3C/338-1244-ND/953292 )Happy listening!

Im going to show some of technical ignorance here, but are you referring to the big caps, 10,000 uF that are connected via the bridge rectifier? I think I can pick up a set from QA-Con , I think that's the supplier on eBay for about 50 bucks. They also sell full kits of all the smaller caps as well. What's the story I hear about "conditioning" amps that haven't been used for a long time with a variac or other type set-up? Thanks again! Off to radio shack to get some phono-kack bulkhead mounts to take out these headset jack type input jacks.

Yes- those are the ones. Be careful from whom you buy the caps. Believe it of not; aluminum electrolytic capacitors have a shelf-life. re: the variac- It's good to bring the voltage up slowly(and, "reform" them), when electrolytics haven't been powered for a long time. Some good info here: ( http://www.allegrosound.com/index21.html )