Eric, hififan, Tim, what are your thoughts on the above post. I want to correct this issue so I can retain my Tara labs cables,,, if that's possible
HELP AFTER MY MODS, My tweeters are subdued and weak-
So I have a pair of Mirage M1 speakers, I changed the caps in the crossovers to Jantzen Superior Z (for the tweeters) and standard z for the mids and bass.
I also changed the internal cabling to Supra Classic 2.5.
First Impressions- Not burned in yet
The highs are there but really recessed in the background. Theres a song I reference and it has a steel guitar solo, I can bearly hear it through the vocals because its seems recessed so far back.
SO HERES THE QUESTION- Is that a symptom of unburned in cables and or caps, or is that just what Supra cables give you?
When I changed the internal cabling a few years back on the same model speaker, I used DH LABS t14 Silver plated cable, This had the opposite effect, it was super bright and fast, but it smoothed out and the brightness relaxed, leaving a lot of detail but not so much your ears bled.
But here its the opposite, its dull on the top end and the vocals kind of take over and blur out the top end.
I also changed the internal cabling to Supra Classic 2.5.
First Impressions- Not burned in yet
The highs are there but really recessed in the background. Theres a song I reference and it has a steel guitar solo, I can bearly hear it through the vocals because its seems recessed so far back.
SO HERES THE QUESTION- Is that a symptom of unburned in cables and or caps, or is that just what Supra cables give you?
When I changed the internal cabling a few years back on the same model speaker, I used DH LABS t14 Silver plated cable, This had the opposite effect, it was super bright and fast, but it smoothed out and the brightness relaxed, leaving a lot of detail but not so much your ears bled.
But here its the opposite, its dull on the top end and the vocals kind of take over and blur out the top end.
- ...
- 78 posts total
By the way, I completely agree with georgehifi's recommendation of pulling these out from the wall also to start. Hopefully leave them out, but if your high end doesn't return as strongly as you like, as you move them back towards a way, the higher frequencies should be what you hear reflected first, reinforcing or enhancing the high end a bit.... good luck in your journey brother, sounds like fun. |
How can I tell what the resistance should be, that device that Tim posted , will that tell me the correct resistance? If I measure the other crossover that I haven't changed any electrolytic caps out of yet.This one cost more, but easy to read: https://www.amazon.com/Peak-166225-Atlas-ESR70/dp/B005NIBEYU/ref=sr_1_1?s=industrial&ie=UTF8&... Yes, you can swapping those resistor to fine tune or simply add a resistor in series to the new caps to make the ESR same as the existing caps. |
- 78 posts total