MM cartridges and capacitance

Adding capacitance will in some cases flatten the frequency response of the cartridge. Shure V-15s use to have a midrange droop that could be corrected by the proper loading. Ortofons use to come from the factory with a "cap 210" which slipped over the pins in Europe; I was a dealer for them then and tried to get some but the American importer had never heard of them. As you have probably seen almost everything about phono cartridges in contentious but I thing it safe to say that in some cases at least loading can be of considerable importance.

I have one of these CAP210 things on my Ortofon on a VMS20E MKII. Did not even know it was there. Those cartridges need 400 pf per Ortofon, which is more the most pre and cables can provide. I forgot I did not switch in any capacitance, so I set the maximum of 220, plus cable, plus the unknown CAP210, which equalled over 600pf, which seemed to make playback overly noisey ?

Load and cable capacitance will interact with the inductance of the cartridge's coils to produce a resonant peak in frequency response, at upper treble or ultrasonic frequencies. Increased capacitance will raise the amplitude and lower the frequency of that peak.

MM cartridges often count on that peak to compensate for what would otherwise be an upper treble rolloff, at frequencies that are within the audible (<20 kHz) part of the spectrum.

BTW, that is the exact opposite of the effect of capacitance in line-level interconnects, where too much capacitance will roll off the upper treble. In that situation, the cable capacitance is interacting with the output impedance of the component driving the cable, which is essentially resistive and not inductive.

Best regards,
-- Al

Al,
From the things I have read, and the cart designer I have talked to on the subject of that resonant peak in frequency response, that peak is waaaaaaay outside the audible band. However, the problem is that it is so large, that just like a really big earthquake, it can cause problems a long distance away, and so can stress phono stages at levels within their reach (which would still be outside the audible band), which causes performance issues inside the phono stage.

The numbers I have seen of that resonant peak would suggest that it is like no earthly peak in comparison but magnitudes higher in comparison from the sea level starting point of the audible band. As I understand what you are saying, cart designers are effectively moving to the foothills of Mordor (and raising it ever higher) in order to make their badly insulated houses warmer.

Then again, I may be misunderstanding this...

From the things I have read, and the cart designer I have talked to on the subject of that resonant peak in frequency response, that peak is waaaaaaay outside the audible band.

T_bone,

That's true in the case of MC's, because of their much lower inductance (which results primarily from the smaller number of turns in their coils). But in the case of MM's, with more turns and much higher inductance, the peak occurs at much lower frequencies. See the following:

http://www.hagtech.com/loading.html

Your comments about the possible effects on phono stages of the peak that MC's can produce, at very high ultrasonic frequencies, are quite correct btw.

Best regards,
-- Al