Need help - Set up Helikon using test LP


Over the weekend, I was setting up my Helikon on a Vpi JMW 10.5 arm using the Hifi News test LP and I ran into some problems. The table was a Vpi Aries.

There are four tracks (6 to 9) on the test LP to help setting up the anti-skate. They are 300Hz pure tones. Each track is a few db louder than the one before.

I played the lowest level track (track 6) and it was fine. The 300Hz tone was beautifully reproduced on both channels with equal loudness.

I than played the next louder track (track 7). The right channel immediately buzzed, indicating the need for anti-skate adjustments. I tried twisting the arm leads both clockwise and counterclockwise, one turn at a time, up to 3 turns; but the right channel buzz still persisted.

I also played the track 8, which is a few db louder than track 7. This time the right channel buzzed loudly for a couple of seconds and it jumped track.

The Aries has been perfectly leveled. I checked it with a bubble level and a 10” carpenter level.

The tracking force was set at between 1.75g and 1.80g; it is difficult to be exact due to the limited resolution of the Shure gauge. But in any case, it is at the maximum recommended value so I doubt that was the cause.

The arm was running dry, no damping oil added.

Has anyone tried this? Any help/comments will be greatly appreciated.
sidssp
Cp, sorry if I overdid it. Sometimes it seems like I'm not getting through to everyone.
Sid, I just received my Hi-Fi teat record yesterday. I will test it on my Aries/VPI 10.5/Benz M2 and then my Helikon. I will report back.
TWL...your advice clearly seems as though you have great experience in this area. We all (vinyl lovers) thank you for your candid and straight forward remarks (although we sometimes don't want to hear the truth).
Let me check my cartridges out and get back to all.