Hi poonbean,
Look at my Virtual System page. You can cut out the maple for the motor. Rest it on the cutout and then experiment with different shings underneath the cutout. Placing it on Jenga blocks to bypass the rubber feet helps IME, but don't remove them as I have read that the screws hold some of the motor's internals in place.
Thread drive is a big improvement over the belts.
Best to you,
Dave
Look at my Virtual System page. You can cut out the maple for the motor. Rest it on the cutout and then experiment with different shings underneath the cutout. Placing it on Jenga blocks to bypass the rubber feet helps IME, but don't remove them as I have read that the screws hold some of the motor's internals in place.
Thread drive is a big improvement over the belts.
Best to you,
Dave