We Need A Separate Forum for Fuses

If so, then something else is afoot as I’ve clearly heard a better presentation when the fuse was in the correct orientation with three different brands. The odds of just breaking contact and reinserting a fuse on three different occasions doesn’t hold water as I’ve even put the fuses back in the wrong way only to hear the difference and take them back out and put them in the right way (not three times but once was enough).

Maybe Clark’s three laws applies:

1. When a distinguished but elderly scientist states that something is possible, he is almost certainly right. When he states that something is impossible, he is very probably wrong.
2. The only way of discovering the limits of the possible is to venture a little way past them into the impossible.
3. Any sufficiently advanced technology is indistinguishable from magic.

You can add a fourth, which would be a variation on the 3rd, which would state:
     4. Any sufficient advance in audio perception is indistinguishable from
         magic when it can’t be measured.

All the best,
Nonoise

One indisputable fact for sure is you change a fuse and you also change the connection. No way to get around that one! Everyone knows connections do matter. Right? How do you get around that one in order to be sure its the fuse and not just the connection changing the sound?

 If you treat a regular fuse with contact enhancing gunk does that make it a fancy fuse? Inquiring minds want to know!

What if the properties of the gunk changes with age (like most of us and not usually for the better) and the connection gets worse over time not better? is there some high end gunk remover for that?

As I've already said, I've swapped out three different fuses and they all sound better one way than another and when replacing one set of fuses, I put them in the wrong way and it was immediately apparent. 

Once you orient the fuses by placing them so that they read the same as the print on the PCB, or the other way (using the orientation as reference), it isn't due to chance reinsertion. It's the orientation of the fuse. If you're saying that it's due to reinsertion, then why does it consistently sound better one way than the other?

Also, tell me how the contacts of the holder change when inserting something circular. 

All the best,
Nonoise

So does an 18 gauge cable sound better than a 10 gauge cable? 
Does any fuse sound as good as no fuse? 
If no fuse truly sounds better, why can't fuses sound differently? 
I've never had the heart to purchase any crazy expensive fuses, but I have twice purchased cheap designer fuses on Fleabay. 
They are called Aucharm..... They were not a different world over stock fuses, but you could hear them.  Still don't have the guts to buy mega buck fuses, but I can say that fuses can make some sort of difference, for me not huge, but these fuses were like $4 or so. 

 
mapman
One indisputable fact for sure is you change a fuse and you also change the connection. No way to get around that one! Everyone knows connections do matter. Right? How do you get around that one in order to be sure its the fuse and not just the connection changing the sound?

By careful testing.

mapman
If you treat a regular fuse with contact enhancing gunk does that make it a fancy fuse? Inquiring minds want to know!

Sure, why not? 

mapman
What if the properties of the gunk changes with age (like most of us and not usually for the better) and the connection gets worse over time not better? is there some high end gunk remover for that?

What if it doesn’t change? What if electrons get old and cranky?