Who's modded modified speaker's cross -over?

I've never modified a speaker crossover, however I've upgraded the crossovers of 15 pairs of speakers over the years. I've used Panasonic metallized film or Solen capacitors of equal value for the caps pulled. Once I used Auricaps, but they tend to be expensive and should be used with higher end speakers.

I upgrade the internal wiring, usually with decent Audioquest or Kimber and pack the corners with rope caulking. Hope that answers your inquiry.

If you're looking to save some $$$ I would suggest replacing the tweeter caps first. They're usually smaller values than the bass caps, which tend to rise in price as you get bigger and bigger. You'll probably hear the most improvements there. I always liked Sonicaps for their price/performance ratio. You can also bypass those caps with a .1uF Sonicap II for added transparency.

I'd also suggest replacing the tweeter resistor with a Mills. Keep all the values the same.

Enjoy,
Bob

If you're looking to save some $$$ I would suggest replacing the tweeter caps first. They're usually smaller values than the bass caps, which tend to rise in price as you get bigger and bigger. You'll probably hear the most improvements there. I always liked Sonicaps for their price/performance ratio. You can also bypass those caps with a .1uF Sonicap II for added transparency.

I'd also suggest replacing the tweeter resistor with a Mills. Keep all the values the same as the originals.

Enjoy,
Bob