Who uses long interconnect like in dealers?


Ideal setup has front end components close to listening chair and run long interconnect between pre and power where power amp sits in between speakers; I have seen many high end dealers to adopt this setup and result is usually more than great. This way front end components do not obstruct speaker imaging and can also avoid bass heavy (vibration) location. But if that is ideal, why do I rarely see long interconnect for sale in used market? I don't think people only upgrade components and short interconnects?
semi
I do. Two 6 meter pairs from preamp to amp. Good question (your 2nd to last one). I have one 6 meter pair of Discovery Signature IC if you are interested.
My source equipment is on a side wall and my amps are between the speakers. My IC's to the amps are 4m and my speaker cables are 1m and 1.25m (system is bi-amped).

I have also noticed that there are very few long IC's on the used market. Maybe people don't do this much because the initial cost is so high. Good IC's can cost $1K or more, and I'm not talking about the really expensive stuff. I would love to buy some Audience or AZ 4m cable but just can't quite get there with the finances.

So I'll just continue to watch for that rare used pair to come along and hope someone else doesn't beat me to them.

Good listening.
On your second to last question, perhaps the answer is it's too expensive to upgrade? I use a 40 foot run between my preamp and power amps/active crossover, and that has always been the last thing that would get upgraded because of the cost. I've tried to make that as good a cable as I could, given the limited choices available for that long a run, to avoid having to change it. And it's also possible, I suppose, to send the long run to the manufacturer to reterminate in shorter runs, then sell those, which would be an easier sell in the used market.
I've been using a 6m length of Kimber PBJ (original cost $150) for several years in order to get the source equipment away from the speakers. I am about to change to a 5m length of Kimber Hero (cost $500 w/WBT 0108's) and expect an improvement in sound without significant cost. I've looked for some Hero on the used market for a while but haven't seen anything longer than 3m, so I'm buying new (got to keep up the relationship with the local dealer!). The next step up in the Kimber line is a BIG jump in price (> $1000) so this is where I stop! The important thing when going with long interconnects is making sure the electrical properties don't lead to signal loss over long runs. The Kimber interconnects are very good in this repsect since they are not shielded (and no I have not had problems with interference). I would check with your preamp and amp manufacturer to get their recommended maximum inductance and capacitance values for the interconnect. You'll then have to get the data for the interconnect and do a little math. Kimber has this on their website, others might too. Hope this helps!