XLR-Balanced Hybrid Hi-End Cable

Signal Cable's Silver Resolution is a nice "hybrid" that you can check out. I used to own these and they are really good cables. But when I switched to ClearDay Silvers, it was a major upgrade in sound. I did not experience any "shiny" bass. But I believe every system is different. Did you reach out to Paul at Clear Day?

Plenty of great cables out there that's for sure. Narrow it down to the ones you're interested in and see if you can find a store or if no store local I've had great luck with the manufacture sending them to me direct which is a no brainier - Try before you buy.

Paul of Clear Day Cables is a great guy and he does make very fine cables that embarrass many other brands out there that sale for much more. Paul always sent me cables with no money up front and paid after I knew I wanted to keep them. Bought many, many cables from Paul. 

I'm still enjoying my Clear Day Cables but have moved them into my daughters system and now using WyWires. Paul's cables are very good but the WyWires just take it to another level as they should because they cost more but the value is there as well. I haven't completely changed over so my system has a mix of the two that work very well together as well.

Both these lines are fine cables but you may prefer one over the other or another. I can say both Clear Day and WyWires will send to you direct and return your money if you don't like them; both great guys to work with.

The whole point of the balanced line system is to eliminate cable artifact, and to that end sliver and gold wire should not make a difference! However, the balanced line system is a standard and if the standard is not supported by the equipment in use, cable artifacts will appear.

Its not that hard to support the standard. Here it is, in a nutshell:

1) pin 1 ground, pins 2 and 3 are signal (usually pin 2 is non-inverting and pin 3 is inverting)
2) ground is ignored at the input and output
3) the cable will be a twisted pair within a shield
4) the impedance of the drive circuit will be low.

A common problem is that many high end products do not ignore ground! If signal currents are present in the shield of the cable then the construction of the cable will become audible.

I am able to use very long and relatively inexpensive cables on account of the fact that the equipment in my system supports the balanced standard (also known as AES file 48). Installation of high end cables really does not change the sound- and that is how it should be (and fundamentally different in this regard as opposed to single-ended cables).

Ralph, are using Mogami Gold Studio, available at Guitar Center for $39.95/pair of 3' balanced cables with Neutrik XLR's?