2. amps-preamps
  3. 1180691735

Your Fav EL34 and why?


I am looking for some info on the EL34 tube and it's various makers, mostly current ones, but input on previous itterations of these tubes which fall into the NOS cat are quite welcome and would add some contrast.

I'm assuming like all tubes that the EL 34 tubes sonic sigs vary dependant upon manufacturer and era, as do so many other tube types.

What is your experience with this EL34 TYPE, and why did you select the one (s) you use now?

As always - Thanks so very much.
blindjim
soundwatts
186 posts
 
http://www.upscaleaudio.com/product.asp?itemid=493&catid=86

Blindjim here is a link to the Mullard reissue on upscale audio's site. I find the bottom end to be more defined than the SED in my system.
blindjim OP
2,837 posts
 
Soundwatts
Mullard re-issue, check. Upscale, uncheck.
ptmconsulting
1,000 posts
 
"Is good bottom end a given with EL 34s???"

I found that the bottom end was effected mostly by using the correct speaker taps on the amp. With my speakers the 2 ohm taps worked best for the bottom end, but the 4 ohm taps sounded better in the mids. Go figure.

Enjoy,
Bob
stevecham
3,298 posts
 
Now running a new quad of KT77s from JJ in my CJ CAV50 and these are as good if not a little more dynamic and full compared to the Winged Cs.
blindjim OP
2,837 posts
 
Stevecham

I'll bear that in mind.

Anyone ever heard of BOI Softworks? San Diego, Ca.

Thanks.
More to discover