ZYX Airy 3 Best SUT


I want to run an Airy 3 via a SUT into my Audible Illusions 3A MM input. The gain on the phone stage is 28db & the line stage is 30db. I am looking at upgrading my preamp further down the track so this is only a temporary set up, I don't want to spend big money only around $1,000. According to the specs the output on the Airy is 2.4mv & the Recommended Load Impedance is >100 ohms.
Could I please have some recommendations?
Thanks in advance.
128x128dolphytrane
I thnk it's a typo above... .24mv. What about the EAR MC4?

I bought one partly by dealer trail and partly from the comments on Ultra Audio. The reviewer did use a Airy 3...

http://www.ultraaudio.com/index.php?option=com_content&view=article&id=197:ear-mc-4-step-up-transformer&catid=37:full-length-reviews&Itemid=2
I agree with Mofimadness. 58dB + 2,4mV is really strong.
Anyway, whenever you think you want more, check out the various Fidelity Research SUT's. You can find them in ebay from time to time, they are good quality.
Furthermore...

the Airy 3's output is actually higher than .24mv if industry standard test tracks are used. ZYX uses a less commonly known test LP to measure output, one which results in lower numbers. Multiply by about 1.34 to get an output that's comparable to most other carts... ie, around .32mv.

ZYX's impedance spec of > 100 ohms is when using an active gain stage. That figure is irrelevant for stepups. Many years ago I did the math and then carefully optimized our Bent Audio stepups for Airy 3 and later for UNIverse. It took a lot of trial and error, as the tiniest resistor changes were audible. Calculations are lost in the depths of time but the Bent's ability to easily swap resistors was very helpful.

Even better would be a design that lets you swap resistors on both the primary and secondary windings to control resonance peaks in both the cartridge and the tranny (Zobel network). Truly matching an SUT to a particular LOMC requires a lot of work, not to mention a fair sized pile of resistors.

All that said, one of the best, untuned SUTs I ever heard with a ZYX was a friend's Cotter. If you come across a used one it would be worth buying.
Dougdeacon I am using the Universe copper and I don't load my phono stage at all. I am using Aesthetix Io Signature. I found by loading I lose the air and dimension of the soundstage and the high end becomes duller. So 47K sounds great to me.