Can you ever have too much power?


Is there a limit beyond which power is counter productive? Or is it like cars, where there no reason to have a 454 hp Corvetee other than because you can afford too?
rogocop
I used to go for MONDO power when running SS amps (class A/B). Now that I've switched to tubes, I like to use reasonable powered amps (say 50%-75% of rated speaker handling power). I'm using an Atma-sphere M-60 MkII.2 (60 watt mono's). Replacement power tubes 6AS7's are relatively cheap ($15-16 ea.) but even so, at this price, a set of 16 (8 per monoblock) will still cost $240-. At least Ralph doesn't run the tubes at maximum parameters, so a set should be good for 2-3 years. Other manufacturers run their circuits with the tubes maxed out (and some can be much more expensive than the 6AS7's) and are know for chewing up tubes (under a year). The MA-2 Mk. II.3 mono's at 220 watts requires a total of 40 tubes...you do the arithmatic! Not to mention the the way, WAY higher list price for an increase of slightly less than a 6 dB's of power gain over the M-60's! Why pay "mucho dinero" for something that you don't need (braggin' rights?) Especially since "tube watts" don't clip out like transistor watts will. Then there's the heat factor. Since I'm in an apartment, the air conditioning fan unit is in the hallway, and I must shut it off for any serious listening. Windows are closed (so as not to piss off the neighbors...and the management). This can be a challange on 110 degree day of an Arizona summer! At least I can keep the amp in standby (filaments on, plate voltage off) when not listening. It's a class "A" amps, so the filaments aren't the heat generators or power hogs). If you're running a class "A" transistor amp, you should leave it on all the time. Not only do they generate a ton of heat, but the idle current (power on, with no signal) can EASILY add $20 to $100 to your monthly power bill. But who ever said "braggin' rights" come cheaply!
Yes, I used to think that I needed a 3.5 watt 2A3 amp, but I found out that my system did all I wanted with a 2 watt 45 amp instead.
Consider the following. Quad speakers have a protection circuit to keep them from being over driven. However, it has been pointed out more than once that less powerful amplifiers tend to trigger the protection circuit more often than high power amps. Enter current management and headroom; amplifier control is at least as important as Watts and many high power amps do it better.