Turntable Platter Demagnetizing


I was wondering if I use a tape deck head Degausser if that would demagnetize the turntable platter. Anyone out there have some thoughts on this also any other ideas about this matter ?
128x128zoobull
Before I respond I have to Apologize to "czarivy" I need to put my Ego in my back pocket. After reading your response your Analogy is spot on again I'm sorry.
Thank you for the responses and ideas everyone I'll check into the Furutech Destat and Damag >benjie and ebm
"Steel" platters are probably stainless steel.  Stainless steel has a very low iron content and is generally regarded as non-magnetic.  Furthermore, ebm, copper is non-magnetic too, unless you wrap wire around it and run a current through the wire. Everything said about static electricity being the culprit is correct, IMO.  There are several available cures or treatments for static electricity in the context of playing LPs. (Brushes, anti-static guns, sprays, choice of platter mat, etc).  I don't know what Furutech "Damag" is, but if it has anything to do with de-magnetization, then you don't need it to solve this problem. "Destat" sounds more like what you need.  Any on-line vendor like Needle Doctor, Audio Advisor, etc, will have one or more products to reduce or eliminate static electric charge that can build up on platters or LPs.

Cast iron is actually quite a good platter material, in that it is less resonant than most materials. The trick is to keep it away from the cartridge, with, say, a 1 inch graphite upper platter. Nottingham Analogue does this, and it works very well indeed.