My Audio Research experience


To all you goners out there, here is my experience with Audio Research.

Approximately four years ago I purchased an AR Reference 75 power amp.  It was on special at the time and I bought if from a dealer in Brisbane, Australia.

I used the amp for the rear channels of my home theatre system which I only use occasionally because I travel a lot for work and I mainly listen to music.

One night I switched the amp on and a white flash and burning smell came from the amplifier and it didn’t power up.  I thought it may have been a tube, and because I had no spares, I reported the problem to my Brisbane dealer and via email to Audio Research.  A copy of the reply sent from AR on the 5th March 2016 follows:

'Thank you for choosing Audio Research and the REF75. I suspect you had an internal tube arc. The internal tube short can also take out a plate or screen resistor. So just replacing the tube will not fix this problem. The resistors also need to be replaced. You can confirm this by checking the bias for this tube. If the bias reads zero, a resistor is open.  This is an easy repair that our distributor in Australia can do.

The SE update for the REF75 comes with a complete new set of tubes including a new set of KT150s.  This is the only way it is sold. If you so choose, Our Australian distributor can also install this SE upgrade for you while the amp is in for repair.'

I then proceeded to order some more tubes to see if a replacement tube would fix the problem.

I ordered the following tubes:

2 x Electro-Harmonix 6H30Pi Gold with Matched Triodes (Balanced)

4 x KT150 Power Vacuum Tube - [Matching (10+ tubes)]

4 x KT120 Power Vacuum Tubes - [Matching (10+ tubes)]

When they arrived, I tried the new tubes but they didn’t fix the problem as the amplifier failed to switch on.  I then contacted my dealer and freighted the amplifier to Brisbane for repair.  This was done in June of last year.  I included all of the above tubes in the package in case they were needed.  I also would have liked the amp to be upgraded to SE status using the tubes supplied if possible.

In September/October last year I enquired about the status of the repair and before Christmas enquired again. After again emailing AR, I was contacted by the Australian Distributor who told me that the service agent in Brisbane had been trying to get parts for the wrong amplifier and that the amplifier would be transported to Melbourne for repair.  I asked them to get me a price for the upgrade using my tubes.

In January/February of this year, I was contacted by the Australian Distributor and had to supply proof of purchase because there was a dispute over whether the amplifier was in fact under warranty when the fault occurred.  I again asked about getting the upgrade using the supplied tubes which were still with the repair agent in Brisbane.  Eventually I was told that I could have the upgrade using AR tubes only, for the heavily discounted price of $3,000 Australian.  Nothing like gouging your customers!!!!!!  Especially when I could have bought a small car for the original cost of the amplifier in Australia.

I chose to just get the original amplifier repaired under warranty which I was told needed a new main circuit board.  This week my amplifier finally arrived back home after nearly 12 months away for a repair under warranty.  The original tubes have been put in a box with ‘Faulty Old Tubes,’ written on the box.  The tubes I sent with the amplifier have not been returned, and no replacement tubes have been included.

I am amazed that the initial fault destroyed six tubes, so I have asked how the Distributor tested the tubes to determine that they were faulty.  I am now left with an amplifier that doesn’t work and 10 expensive vacuum tubes missing somewhere in Australia.  I am also left with a conundrum, if when I finally get my tubes back and use them to ensure the amplifier works, what happens if it doesn’t.  Will AR then blame me for any fault that occurs on power up because I haven’t purchased tubes from them at their heavily marked up prices????

For me I will never touch another Audio Research product for as long as I reside on this planet.  I will be telling all my audiophile friends and putting this report on every forum that will publish it.  Best of luck for the future Audio Research and may you drown in your policy mess!!!

thazeldean
I agree that it does seem difficult to defend ARC's repair policy, and I own an ARC preamp. Having read this thread, I would probably have it serviced somewhere else. Fortunately for me, RHB Sound Dezign is close by. Bob does great work.

That said, it is difficult to compare the OP's story of a damaged amplifier with a damaged remote control. Comparing ARC to Allnic service in this case is like comparing apples to oranges in my opinion.
Not really jmc.  The ARC story shows their disdain for their customers.  The Allnic story shows that they care about their customers.  Nuf said
@thazeldean , you are certainly entitled to your opinion, as are others here. I know how you feel. I, for one, will never buy BAT gear again due to many issues.

That said, folks who complain about one company just had the misfortune of poor customer service and/or design flaws. Not unlike folks who have had issues with a shipping company. Some folks have been burned by FedEx, USPS, UPS, etc. They will never use these shipping company services again.

Search the web long enough and you will find good and bad about any and all companies, including Allnic (which I also own). 



Should replacement vacuum tubes be required to complete a repair or update, only Audio Research tubes will be installed in order to assure product performance and to validate the 90-Day Limited Service Warranty.

If a customer refuses the use of Audio Research parts and/or tubes needed to complete a repair or update; the product will be returned unrepaired at the owner’s expense.
http://www.audioresearch.com/en-us/company/service-and-policies

"SHOULD REPLACEMENT VACUUM TUBES BE REQUIRED"

SHOULD.......
IF the service center in Melbourne had received the OP's new tubes they would have tested the new tubes and if they tested good they would have used the tubes in the final bias adjustments/bench testing, and listening test. The new tubes would then be pulled from the amp for shipment and sent along with the amp back to the owner.

I would be willing to bet the OP's new tubes were never sent/shipped with the amp to Melbourne by the dealer in Brisbane. Only the amp and the original ARC tubes that were  in the amp were sent to Melbourne.  The original tubes would have been tested in Melbourne and some were found to be defective.

We have no way of knowing what, if any, communications transpired between the service center in Melbourne and the OP. Just a guess there was something.

I would hope the OP takes the time today to contact the ARC dealer in  Brisbane and inquire about where his new tubes are. I hope any emails between all parties were preserved. Phone calls are full of I don't recall that conversation.