Dynavector Stylus Cleaning - dehydrated ethanol???


Dynavector recommends using dehydrated ethanol for cleaning their styli.

Is this what is in Last Stylus Cleaner or RRL #9?

Sounds like I should just break out the Everclear!
slate1
You're not likely to find completely dehydrated ethanol readily available. The everclear (..etc) will, at most, be a 95% EtOH / 5% H2O solution. Getting the last 5% water out of ethanol isn't overly easy (or cheap)...and once you open the container the dry ethanol will eventually (or quickly depending on your ability to store it correctly) revert back to 95/5 by pulling water out of the air.
Thanks for all the responses. I've been using an older Zerodust but have been considering getting a cleaning solution of some sort. I apply a dab of Stylast before each LP too.

I'm going to have to try the much praised Mr. Clean Magic Eraser thing - I could cut a square to fit in the Zerodust case...
Yes, it is in the household cleaner section. It used to come in white only and they are plentiful. However, they have a new one with a blue layer on one side that contains some type of cleaner booster. You DO NOT want to use the blue side. Use the WHITE side only. I cut a sugarcube sized piece and put a toothpick into it and use it that way. I gently push the stylus into the cube (not very deep)and jiggle very carefully. Needless to say, Do not move opposite of record travel direction. Others have glued a piece onto a coin US Quarter and put it on the tt platter. Then, they use the cuing device to lower the stylus onto the white Mr. clean piece a couple of times. If you go to their website, they will mail you a package free. I was in a hurry though and bought mine at a store. There's a lot of threads about it on AA. Good Luck.