N802 speaker cable suggestion

I wouldn't think Audience speaker cables would make a good combo with
N802's. N802's like lots of power. Audience speaker cables are based on the
questionable notion that thinner gauged cables sound best. It's pretty basic
-- you're going to suffer higher resistance with thinner gauged cables, which
means you're going to lose signal over the audio band. I would use
something much lower gauged, which is probably why Arthur has had such
good luck bi-wiring with the Sartori and Hologram. That's a lot of cumulative
gauge -- he's reduced resistance to a complete non-issue. Not saying you
have to go to that expense -- you might try other lower cost, lower gauged
cables first.

Audphile - I've been auditioning speaker cable through the Cable Company recently and I can tell you its the ONLY way to audition cable. After reading tons on these forums, I figured the Cardas line was the one for me. When Cable Co actually sent me the big box of cables, I discovered that the Cardas didn't work well in my system at all, and the best sounding was a brand I never even heard of before (Purist Audio).

As for the B&W's, I owned a number of them (especially the Matrix series) and can tell you the B&W's as a line just seem to demand biwiring to sound their best. I wouldn't even consider single wiring them.

If only I could reduce resistance to a complete non-issue in other areas of my life, my wife, my kids, my work.....oh well, gotta have a dream....

I've replaced my Kimber silver speaker cable that comes with the B&W Silver Signature's with Sonoran Plateau speaker cable. It's a lot more natural and less grainy than the Kimber's, although I didn't even realize the Kimber's were grainy until I auditioned the Sonoran's.

You can audition the Sonoran's for 30 days and see for yourself. Go to http://www.audiopoints.com and check them out.

AND, like LarryB suggested, please don't even consider any option except bi-wiring, and with two separate runs of cable. Don't get a bi-wired set please, there is a difference.

That's what I've noticed, as I mentioned in my earlier post, that single wire run doesn't do it for the Nautilus. I don't know how Audience thinks that the B&Ws are better with a single run of AU24. But I did send them an e-mail a while ago and got a response that my speakers, the N803, would not benefit from a bi-wire run. Hmmm. This totally contradicts with what I've found to work best when trying different cables. The way to go is bi-wire for the Nautilus, but I do agree there will be benefit from bi-wire run with 2 sets of cables. Never tried it though.