Dielectric grease and tubes

I wouldn't think you'd want to use dielectric grease since its sole purpose is to prevent the conductance of electricity.

Check. Won't use it. The only reason I thought of it was because when you install spark plug wires you dab a bit on the electrical connections prior to installing them. Didn't know if there was a similar use here.

Dielectric grease is used on non-conducting parts of electrical assemblies to block stray current. The pins of tubes need the best possible contact with the tube socket and dielectric grease couldn't do anything but hinder that.

Why wouldn't it work to stop mini-arcing? I thought this was the benefit of dielectric grease as well as one of the causes of poor sound from wall plug connections.

Its non conductive so if it doesn't completely wipe off the pins as they enter the tube socket you might lose the tube. Its also only soluble in methyl ethyl keytone and mineral spirits. I do use it on the pins of my trailer socket of my truck with success. I should probably only use it on the rubber gasket but you have to be careful because it can break down silicon rubber.