Audio-Technica AT-ART9 phono cartridge

BELOW IS THE ART-9 SPECS FROM THE AT WEBSITE. LOOKS AS IF IT HAS A 12OHM IMPEDANCE WHICH SHOULD WORK WELL WITH MY SUT. VERY INTERESTING, THANKS FOR THE TIP.
Specifications
Type: Magnetic Core Moving Coil
Frequency Response: 15 to 50,000 Hz
Channel Separation: 30 dB (1 kHz)
Channel Balance: 0.5 dB (1 kHz)
Coil Impedance: 12 W (1 kHz)
DC Resistance: 12 W
Force d’Appui: 1.6 à 2.0 g (standard 1.8 g)
Tracking Force: 1.6 to 2.0 g (standard 1.8 g)
Vertical Tracking Angle: 23 degrees
Recommended Load Impedance: Min 100 W
Coil Inductance: 25 mH (1 kHz)
Static Compliance: 35 x 10 – 6 cm / dyne
Dynamic Compliance: 18 x 10 – 6 cm / dyne (100 Hz)
Output Voltage: 0.5 mV (at 1 kHz, 5 cm/sec)
Stylus Shape: Special Line Contact Stylus
Cantilever: 0.26 mm Ø solid boron
Stylus Construction: Nude square shank
Mount: 1/2” centers
Dimensions: 17.3 (H) x 17.0 (W) x 25.6 (L) mm
Weight: 8.5 g
Accessories: 1 non magnetic screw driver; 1 brush; 2 washers; 2 x 12 mm mounting screws; 2 Nuts; 2 x 18 mm mounting screws; 1 plastic protector; 1 set of PCOCC Lead Wires (AT6106)

Any new thoughts, buyer's remourse, etc. on this cart? I'm close to pulling the trigger and would appreciate an update. I see them on eBay for $950 from Japan & HK. Any experience with those vendors? Any consensus on ideal impedance. I see the spec at100>; and one recommendation at 120. 

All comments welcome.

Thanks,

wanders ...

No regrets at all. The cartridge is wonderful. Highly recommended. 

Sorry, no experience buying from Japan. Got mine from LP Tunes. 

Please let us know your experiences with the ART-9. 

You can refer to this thread for a detailed discussion on ART-9:
https://forum.audiogon.com/discussions/pani-new-art-9-up-and-running

" I see them on eBay for $950 from Japan & HK. Any experience with those vendors?"
No personal experience, but 2juki in HK has been praised by many in the Asylum. Do a search there. I’m thinking of getting an Art-9 and would buy from him.