Bridged amp with electrostatics..


Is there any problem to use bridged amplification power with electrostatics?
I've heard that bridge amplifiers are very powerful but they can't see an impedance load very well.
Are there any other problems with this match?
carloscotland
So are you looking for an amplifier that is based on a bridge circuit then?

Atma-Sphere, BAT, Einstein, Joule Electra are a few that come to mind.
Yes, but they mention not to ground any crossover or tweeter as bridged amplifiers have both red and black terminals "live". I'm confused if I could use an amplifier like that or what I should do to prevent any damage.
Cheers
I think that there is a confusion of semantics here. Carlos is, I think, talking about bridging a stereo amp to provide more power for a single channel. Some amps are delivered from the factory with a switch to allow "bridging". I am showing my ignorance, perhaps, but I do not think that that is the same think that Atmasphere is referring to. Take this with a grain of salt, because I know nothing about circuit design (but I do know that the tube amps he mentions sound great).
Sorry I may bring some confusion; I am keen to buy a MF KW amplifier, there are two models. One is integrated delivering 650W and theother is a power amplifier only delivering 750W; both are bridged per se,by design and non-reversable.
I have recommended this amp alot. Moscode 401hr. I use it with electrostatics. Bridging is acomlpished with a flip of the switch. I am sure you mean bridging and not biamping.Biamping is where you use a different amp for the top and the bottom.