2. amps-preamps
  3. 135898-112562

Does anyone leave their amp and preamp on all the time?

I listen most nights after work. I find that the system takes a while to warm up and sounds it's best if it has been shut off. So I leave it on. I always have and this is vintage stuff. The amp is a 25/25 Bedini class A. It stays warm but never hot. It has never caused an issue but recently I've been speaking with others that were stunned that I would do this. So let me know if I'm the only one that lets it run. Do you shut off the equipment after each session?
vinylfan62
somyak's avatar
somyak
1 posts
 
I leave my Aragon on all the time. Another thing to considered for solid state is that on/off cycling increases the chance of component failure. The heating and cooling accelerates metal fatigue. Electronics manufacturers will repeatedly power cycle devices to weed out early life failures. The down side is that it also shortens the life expectancy of the device. 
cheapbob
49 posts
 
My Denon stays on all the time, as does my music server. The individual nodes (raspberry pi servers) are turned off. My Wyrd and Schiit Modi stay on all the time.
bultaco
43 posts
 
I know a high end dealer whose Theshold amp has been continuously running since 1978.
fleschler
766 posts
 
All tube pre-amps and amps in my main listening room and living room systems are never left on when I'm not in the room.  Tubes are too precious to burn up, the power draw is high on the amps but they run cool which is a good thing. 

However, both video systems use a Yamaha CR 620 receivers which are left on 24/7 and have lasted a decade without incident.  They draw less power and are also quite cool running.
hk_fan
314 posts
 
My preamp (Levinson 326s) and amps (Parasound JC1's) have standby modes which minimize the amount of warmup time.  I wouldn't leave them on all the time even if they didn't however.
More to discover