FYI: VPI HW-19 motors

Robert...thanks for your thoughts. I have bought probably
9-10 of the 3203-001 motors direct from Hurst over the past
25 years or so.

I was a VPI dealer for many, many years and have set up well
over 200 HW-19 tables. I have personally owned over 50 HW-
19 tables and still have several.

I have never had a faulty replacement motor from
Hurst...ever. All have been quiet and performed perfectly.
Maybe you just got bad one?

I haven't tried or used one of the newer model (SP-3923), so
I can't say whether it's better or not.

Mofimadness--I bought a VPI HW19II with an SME IV arm in 1989 (I think). I started listening to it again after a hiatus and replaced the belt, oiled the bearing, replaced the original van den hul cable with a cable from ZU audio (trying to work on RFI), and a Dynavector 10x5. I use a PS Audio GCPH and, with 8 transmission towers nearby, I can't use tubes. Curious as to whether you have any recommendations to improve the sound of my vinyl setup. I think it sounds pretty good but I would prefer wonderful! Thanks. Bob

Bob...you could definitely upgrade the cartridge. The 10X5 is pretty decent, but there are better out there. If you like the Dynavector sound, (I really do, one of favs), I would recommend a 17D2MKII or a 17D3.

Also, if you still have the original HW-19MKII platter, you could replace it and really improve things. I think the TNT MKIV platter is the best and I've owned ALL of the various platters. A Super Platter is better, but they are almost impossible to find in good condition. I have tried the new metal platter and IMHO, still think the TNT MKIV platter is better, (on a HW-19). I know some disagree with this, but that has been my experience. YMMV.

Also if you could find a HW-19MKIII stainless steel and acrylic plinth, they are best sounding of the bunch, but again, some of these parts are getting hard to find.

In addition if you are still using the original suspension, try to find a set of (4) SIMS Navcom Silencers. These work really, really well and sound incredible. Make sure you remove the outer steel bands. Tiptoes for feet are another pretty decent tweek for not a lot of money.

As you can see, there are a lot of things you can do to a HW-19 table. I've done it all on many, many different HW-19s and still think this table is a keeper. Probably the only people that know this table better than me is VPI.

I have read that some people think the later HW-19's were just as good as the later offerings like the Classic. Do you also feel this way and what tone arm do you like on the HW-19's. I have seen that the ET tonearms were often used with this table. Are there better matches?

thanks mofi any sources would be appreciated. my email is bwhitlock56@gmail.com if you have any advice.

Bob