how much power do you need two drive magnpan1.6s


i am buying magnpan 1.6s is my mcintosh mc 352 a good amp for these speakers
majic
Magfan...Its Voltage squared divided by ohms load.

70 volts would be 1225 watts.

I actually made some measurements while my MG1.6 was playing very very loud music. My objective was to see if my 600 watt amp was overkill. I saw peak voltage at a level that would correspond to an amp of about 600 watts. Of course, at more moderate SPL and during most of the music the voltage peak level was more like 12 or 14 watts. Based on my findings I decided that 350 watt CI D200 amps would be OK, and I applied the ZR1600s to other tasks. By the way, my experiment was done with the Maggies seeing only 50Hz and up.
Eldartford ...

I actually made some measurements while my MG1.6 was playing very very loud music.

How did you do this? I would love to know what my speakers are demanding during my play.
Rockadanny...I simply used a digital voltmeter, which makes a measurement about once per second. Careful observation will yield a result very near the maximum brief rms voltage. Then the peak is reasonably estimated as 1.4 times the rms. A peak-reading meter would be better, and an oscilloscope would be best.
Good experiment with some measures.
Now that I think about it....a speaker with a hi-powered amp can see 2x the voltage I mentioned....an amp typically has 2 power rails....plus / minus so the difference between the rails is what the speaker sees.
My International Rectifier class 'd' (for play) has 2 rails with a max of +/- 55v.

What happened to P=IE? By this method.....the max current to the panel (fuse limited to 4 amps, 600hz and up) is as I wrote in my last post.

My Formula, and yours are both correct...My assumptions couldn't be right.

http://www.the12volt.com/ohm/ohmslaw.asp

So I suspect I made a bad assumption of voltage to the panel.
Fact is, the darn thing has a 4 amp fuse which sets an upper limit on amp current, No? If the panel can sustain double the fuses rating and as know, is pretty flat at 4ohms....with a nasty peak at the 600hz x-over, that should set an upper limit to power. The Panel maxes out at about 18 ohms at 600hz and over 6 ohms from 200 to 2000 hz.

Other than a math problem, What is the problem with the rest of my post?

Also, now that I look at an impedence / phase chart of the 1.6, I realize that even for this speaker (fairly benign), the problem is pretty complicated. If you take the 18ohm at 600hz, and ASSUME a max of 5 amps at that frequency, that is Isq=25 x 18ohms = 450 watts at 600hz. Even 7 amps yields 'only' 882 watts....clearly a deal breaker at that frequency. it gets weird when considering music.

http://stereophile.com/floorloudspeakers/595/index6.html

If I had the time/tools ( I am immediately sending away for a Kill-A-Watt.....<20$@newegg) I will measure the entire power needed by my fairly efficient GCC250......than use some kind of fudge factor to determine power to the speaker.
The neighbors have aloud treat instore for them.....!

Thanks, Eldartford for making me rethink this. My conclusion, however, remains the same. It is very likely that Hi-Current is a Magnepan red-herring, given the limits imposed by the fuse and physics....