One more question regarding Warrenh's post about a dedicated ground.
Sean, I searched your posts on isolated grounds here and I am still not sure I understand it.
When we installed my dedicated lines we used 12ga. Romex and 20 amp breakers. We ran each leg in conduit with the conduit tied to the breaker box, but with the conduit stopping short of the outlet boxes (plastic). The ground in the Romex is connected from the Acme outlets to the panel.
The only thing plugged into the outlets are my audio equipment since they are located under the house. I had a hole cut in the hardwood floor behind my equipment rack and ran all power cords out of sight through the floor to the outlets beneath.
How do I change this to make it an isolated ground?
Sean, I searched your posts on isolated grounds here and I am still not sure I understand it.
When we installed my dedicated lines we used 12ga. Romex and 20 amp breakers. We ran each leg in conduit with the conduit tied to the breaker box, but with the conduit stopping short of the outlet boxes (plastic). The ground in the Romex is connected from the Acme outlets to the panel.
The only thing plugged into the outlets are my audio equipment since they are located under the house. I had a hole cut in the hardwood floor behind my equipment rack and ran all power cords out of sight through the floor to the outlets beneath.
How do I change this to make it an isolated ground?