Isolation Transformer or Power Regenerator


How are they different? Is one better than the other?

Let’s first just I assume that I have bad power. I have a Topaz 1.8 (.9 balanced) that I put my McCormack DNA-1 Deluxe (SMcAudio silver upgrade) on recently and the difference in sound was night and day. Was expecting subtle changes but not dramatic changes. The amp right out of the wall did not sound very good at all, which just did not make sense…it’s a good amp. Putting the iso in line explained why. So, my feeling is I need to get fresh power to my entire system. The Topaz in balanced form may have just enough headroom to squeek by (according to Steve McCormack) with just the amp on it. More would be better.

So, should I get a higher power iso (Topaz, Oneac) for the amp and using the existing one iso on the other gear? If so, does it matter if it is a IE-core or Torroid? Some say EIs let less noise through, some say a good Torriod will equal EI in terms of noise reduction and create less noise (EMI) than an IE. Any final verdicts on this?

Or would it make more sense to get a (Exact Power, PS Audio Power Plant Premier) power regenerator and put the whole system on it. Would any of these have enough headroom to cover my whole system?

I already have a dedicated 20A line to this system. Looking for bang-for-buck solution.

My System:

TADAC Tube Pre/DAC = 25W According to Paul at TAD)
Apple TV = 20W (according to Apple)
DIP (Original) = 10W (according to back panel)
Tivo HD = 40W (according to tivocommunity)
Video Switcher = (don't know but could it be much?)
TV = 240W (according to manual)
McCormack DNA-1 Deluxe = 400 (according to SmCAudio)
Paradigm PS1000 powered (250W/750W peak) Subwoofer = I can’t find this, any ideas? Let’s say 375

TOTAL = 1110W
cpalcott
Wow, more confused than ever. The Power Plant Premiere I was looking at is actually a newer unit that is 1500 watts and is reportedly much more efficient, quiet and cooler than the older units (300, 600, 1000, 1200). Is this still not enough for my system?

I'd be fine going the isolation transformer route. But does regeneration achieve anything that isolation does not?
Not going to argue with success. Go bigger. However, might be more hum and certainly more power draw.

http://cgi.ebay.com/Isolation-Noise-Suppressing-Transformer-5kVA-NEW_W0QQitemZ310306755784QQ
does the Equi=Tech meet Canadian code standards as well?

typically Canadian power grid issues mirror US standards so it's likely ok. but i would e-mail Equi=tech about it.
Thanks for the link. So would a 5kva wired balanced (2.5 kva) be enough to run my entire system from the electrical panel? My system at around 1200 Watts would come in at less than half the rated output of the ISO (2500 Watts).