Legacy 20/20 and Tubes

I will have to back Sean's statements on the quality and fit and finish. A buddy of mine purchased a pair and the cabinets were very attractive. However, we could NEVER get the speakers to do anything right. These were a pair of the Legacy Focus I believe. Needless to say, he sold the speakers only months after waiting for them to "break in" and sound better. (That never happened BTW)

I guess the more drivers in a cabinet, the better the speaker! Anyway, my advice is to listen to all the speakers in your price range then make your decision. I think you can certainly do better than the Legacys. Just my opinion. Good luck!

I responded to this thread because I was running an ARC SP16L and Manley 250 monoblocks(on the top), both tubed products. I felt this was a proper response to this thread.

I wasn't bashing Legacy in any way, shape or form.
I have no grudge against them or past experience with their products.

My findings were that these speakers were extremly harsh and fatiguing with good tube gear running the upper freq's.
But, in all fairness, I didn't run them with just the Manley's or just the Aragon. Perhaps doing so would have yielded different results.

Although, I have used this bi-amped setup with other speaks with much better results.

Part of the issue is how much lab measurements can be trusted to tell us how a speaker will sound. No one listens to a speaker from one meter away. And playing a 1-watt signal through a highly efficient speaker such as the Focus would be louder than listening volume. And moving the lab microphone up or down a few inches could change the whole frequency plot. The Focus design is intended to sound right in a room at the listener's position. That is one rationale for the d'Appolito (MTM) array--to adapt to room reflections. So all those dips and shelfs in the frequency plot don't mean much.

But if they sound nasty (or great) in your listening room, that does matter. Maybe the difference between successful and unsuccessful experiences with Legacy speakers comes down to how much carpet and furniture there is, or how high the ceiling is?

Mcargill: The Focus doesn't use anything close to a true D'Appolito design. D'Appolito's follow a specific pattern in terms of driver sizes, spacing between drivers, crossover slopes, etc...

Having said that, i do agree that mic placement could change things pretty drastically, especially with this design. This has to do with the fact that the drivers are mounted not only vertically staggered but also horizontally too. This will produce a pretty strange and random radiation pattern that will be plagued by peaks and dips due to comb filtering. Using this type of design, the ability to localize specific imagery is also reduced.

Comb filtering takes place when you have more than one driver covering the same frequency range and they are spaced apart from each other. While bringing the drivers closer together may reduce comb filtering to a certain extent, all it really does is raise the frequency at where it will take place.

John Atkinson commented that best results would be obtained if one were sitting with their ears slightly above tweeter level. Given that the tweeters on the 20/20 are situated 45" above ground level, this may be pretty hard to achieve for most people of average height sitting on a typical chair or couch. Sean
>

Sean, if people LIKE their speakers, would you please LET them? Without telling them why "technically speaking" they SHOULDN`T like them?????