2. speakers
  3. 1258565458

Loose driver mounting screws on Velodyne HGS-18

Hi folks, I recently removed the grill from my Velodyne HGS-18 (purchased in 2001), and while the grill was off, I figure I would tighten the 6 hex screws securing the driver to the enclosure. I noticed that all 6 screws were quite loose (by several turns). Anyhow, I tightened them all up, and the bass was noticeable tighter afterwards. I contacted Velodyne and asked them if they have heard on seen this happening on the HGS series subs, and they said no. So does anyone out there with an HGS series sub want to take the grill off the sub, and check to see if the screws are loose, and hence you are missing out on some tight(er) bass. Maybe this is a common occurrence, but that people never remove the grill cover and check, so they never realize it, and have been living with loose(er) bass.
bge912
stanwal's avatar
stanwal
3,147 posts
 
This happens to speakers of all sorts, with time or shipping even the tweeter screws will need tightening. It is a good thing to check periodically. You should do it when you first get the speakers, usually the shipping will have loosened them.
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,333 posts
 
It happens - the wood dries out (wood breathes) especially after a year or so and then the screws become slightly loose and vibration does the rest. You probably will not have to tighten them again.
theo's avatar
theo
2,331 posts
 
I find that once I discover a loose screww I remove it completely. Then I injects a small (very small) amount
of glue and replace the screw. I tighten it as much as it will require and I never have had one loosen up again.
The reason you want to use a small amount is that you have enough applied that will keep the screw from self-loosening, but still be able to break it loose and remove it should a driver ever fail.
More to discover