2. speakers
  3. 1258565458

Loose driver mounting screws on Velodyne HGS-18

Hi folks, I recently removed the grill from my Velodyne HGS-18 (purchased in 2001), and while the grill was off, I figure I would tighten the 6 hex screws securing the driver to the enclosure. I noticed that all 6 screws were quite loose (by several turns). Anyhow, I tightened them all up, and the bass was noticeable tighter afterwards. I contacted Velodyne and asked them if they have heard on seen this happening on the HGS series subs, and they said no. So does anyone out there with an HGS series sub want to take the grill off the sub, and check to see if the screws are loose, and hence you are missing out on some tight(er) bass. Maybe this is a common occurrence, but that people never remove the grill cover and check, so they never realize it, and have been living with loose(er) bass.
bge912
jax2
3,031 posts
 
One note on Loctite - It is intended for metal on metal, and not for metal in wood. Not sure how it would work in the latter application, but I'd choose a different adhesive if your screws are going into wood.

Totally normal for drivers to come loose. In fact, in a recent (November?) issue of TAS it was among a list of ten cheap tweaks you could do to improve the sound of your system (tightening the drivers).
tpreaves's avatar
tpreaves
2,515 posts
 
Do not over tighten and strip the threads.
hifitime
715 posts
 
If they are threaded into the wood on any speaker and becomes striped out,its best to use "T-NUTS".They are metal and inserted from the rear.This link is for picture purpose.Link>>>[http://www.stafast.com/products/tnuts.html]
hifitime
715 posts
 
Anther T-NUT link>>[http://www.parts-express.com/wizards/searchResults.cfm?srchExt=CAT&srchCat=829&CFID=2764090&CFTOKEN=49784390]
hifiharv
351 posts
 
Locktight makes a special formula for this particular application. It is called "TITE'N". I used it once with good success on the side rails of Magnepans. This is designed for wood, rather than metal materials.
More to discover