2. amps-preamps
  3. 134891-111133

Mcintosh Integrated Amp MA7200 MM input question

Hi all,

I’ve been a long time visitor of this page but finally decided to post a question after I’ve scoured the forum for answer.

I have a Mcintosh MA7200 integrated amp and I would like to use an external tube pre amp. I understand that I will have to remove the jumper cables on the rear panel connecting the pre amp to the PWR AMP and then connect the pre amp output to the PWR AMP input on the Mcintosh.

Does that mean that my MM phono input on the integrated amp would be useless? In other words, do I now have to connect my TT to an external phono pre amp , then to the tube preamp then to the Mcintosh?

Any comments is appreciated!
btzqabc
btzqabc OP
6 posts
 
I called my local distributor and was told that once the jumpers are removed, the MA7200 can only be used as a power amp OR pre amp but not both separately and the phono on the MA7200 would not work either. He doesn’t sound very sure though. Nonetheless I’m emailing Mcintosh to verify. 

Speaking of the Output 2 , I’ve successfully hooked up an active sub to it for movies. 
yogiboy's avatar
yogiboy
2,678 posts
 
@btzqabc
Output two is for a second amp. A powered subwoofer is the same as using a second amp. If you want to verify this just remove the jumpers on the amp and preamp and see if the subwoofer still operates. If it does then you can use it as a second preamp.
btzqabc OP
6 posts
 
Well, before I could try, the guys at Mcintosh confirmed that once the jumper is pulled, the phono would not work so I’ll need an external phono stage. 
More to discover