That sounds very foolish and it's a great way to fry diodes, rectifiers, and transistors. The only way to fully reform a capacitor is to remove it, put it on a high voltage leakage tester, and watch the leakage drop off as you progressively ramp up the voltage to it's rating. That's impossible to do in circuit. Doing what you suggest would, at best, reform them to their idle voltages and no more. Even if it were a good idea, which it isn't, you'll never reform them to their ratings and you'll only end up with a unit that's just barely on the edge of leaking. Since the only way to do the job "right" (if there is such a thing) is to remove them, you might as well replace them.
Need to recap my Classe Audio DR-8 Amps - need suggestions
I recently purchased two Classe Audio DR-8 amps. The amps were barely used and are in mint condition, but I think I need to have them recapped due to being over 20 years old. I am guessing Classe Audio would be the best place to have the amps recapped, but I am not sure. Any suggestions where to have the amps recapped and what I should expect to pay?
Also should I recap my DR-5 pre amp?
Thanks.
Also should I recap my DR-5 pre amp?
Thanks.
- ...
- 25 posts total
- 25 posts total

