Ortofon Per Windfeld Load Impedance?

Thanks Ralph,
You've validated my position concerning irrelevance of the phono cable as it relates to cartridge loading.

This is Vinyl 101 and I hope others pay attention.

Dear zieman: +++++ " I routinely change loading with different phono cables. The differences are not subtle. " +++++

as Audiofeil and Atmasphere posted almost always ( nothing is perfect ) the cable resistance value per meter is too low for take in count on cartridge loading and I agree with them.

IMHO what you are hearing is due to own differents cable colorations but certainly not mainly because its cable ( really low ) resistance. As a fact you, like everybody, don't want a high resistance cable where you can loose the signal high frequencies ( between other things ), normally a cable designer almost always works on a very low resistance cable.
Of course that maybe in one of those cables that you already try it its resistance could be really high but that is not the standard, as I told you: we are looking for a very low resistance cable as a rule.

Btw, the other subject that I always support is what Atmasphere posted: don't use the cartridge loading like a tone control/equalizer to compensate for " errors " somewhere in the audio chain.

Regards and enjoy the music.
Raul.

Right, so when was the last time you saw a 5 meter phono cable? Try one with a .25 output MC. Then we can talk about what happens in vinyl 102. I believe I can hear going too low as well as too high. This confirms Atmas measurements.

Zieman, since our preamp is balanced we tried exactly that, since the cartridge is a low impedance source. The result- no difference. Single-ended; hard to say what you might hear since single-ended cables tend to be more susceptible to coloration.

You can indeed hear the effect of the load being too low or too high. **That** is why you need to load the cartridge at critical damping *before* you mess with cables!

Atmasphere, Can you, or have you, done the "ring" deal at the end of the phono lead? VS. the cart pins? Have you measured any huge differences that would have you deviate from mfgrs' recommendations regarding loading? What three syllable word is applicable to cart and cable in sum? I know I read this somewhere... I do appreciate reading about measurements that confirm my listening results.