Parasound Halo JC-1 for Thiel CS 5i


Hi,

I have a set of Thiel CS5i's that I am running with a W4S ST1000 amp.

Would Parasound Halo JC-1 mono amps be an improvement? Why?

Thanks,

Dsper

dsper

A point I failed to make in my earlier post is that I am now understanding that I do not need to have a 500 watt amp to power the Thiels so this opens up a host of choices, I think.

But how do I go about eliminating those where the specs would indicate that they are probably not a good match?

Lugging 100 pound plus amps to my home is not fun. The dealer has used Krell and Pass amps that I could try.....

Excellent thread guys. I scored my pair of Thiel CS 2.4SE this week.
Now the fun part of picking/choosing the associated gear for them!

Keep me posted & Happy Listening!
Second note;
Thiel guys, how do you clean/maintain the fit + finish on your speakers?
^Thiel used to recommend one only use "Endust". Most everything else will leave dreaded fisheye. I apply the Endust to a soft cloth not directly to the cabinets. Be careful, especially with older models, cleaning the grill cloths, as it's possible to either push in the domes or if vacuuming to detach the voice coils. Except for the CS 2's (and perhaps other models?) which use an adhesive in addition to the screws to attach the grills to the cabinet, it might be wise to remove the grills before cleaning the grill cloths.

dsper, with the CS 5's it's the amps capability into 2 Ohms that is most relevant. I would only consider amps that could double down and down again into that load. I would recommend by starting with amps spec'd with the capability to deliver at least 400 Watts into 2 Ohms, and ideally 800 to 1600 Watts into 2 Ohms. After that it comes down to the sonic characteristics of the amps under consideration and personal preference.

These speakers amp requirements is perhaps the only reason I don't own them. Driven properly, they are wonderful!

Krell ;-).