Proac Rake angle?


With the D48r, and my current listening chair, with the speakers perfectly level, my ear is at the top of the surround of the top woofer, instead of tweeter level.  I'm assuming that this is not allowing me to get the best tone and image out of these speakers.  I have some outriggers on the way that will allow me to adjust the rake angle more easily.  But I'm not sure if tilting this speaker back to get the tweeter to fire my ear will actually be completely beneficial.  Would this skew the crossover alignment?  Would I be better off trying to find a chair to get lower? Any experience? 
audiolover718
Listening to these amazing speakers as I type. I've got about 500 hours on them and they are a spectacularly precise, transparent and wholly satisfying speakers.

I tried both biwire mogami 3104 and synergistic research atmosphere level 1 single run.   Honestly, once broken in, I prefer the synergistic to the biwire mogami.  The mogami sounds slightly richer, but I lose transparency, speed and focus when compared to the synergistic.   The synergistic are a whole different ball game.  The synergistic cables create ghosts in the room. The Maggie's hinted at this. The proacs are supernatural in their presentation. They are so transparent, that the mandatory warmup on my preamp is so much more noticeable.   It  doesn't get truly "hallucinogenic" sounding until about 30-45 minutes, but it when you reach that time, it's like an aural thrill.   

Now honestly, I don't know if it's that the speakers don't respond well to biwire with my equipment, which would go against conventional wisdom around here with proac, or that the mogami is just that much worse of a cable than the Synergistic.  But I cannot get the magic focus and coherency with the mogami biwired as I do with the synergistic single run. But at the end of the day, we all must trust our ears, and do what we feel sounds better to US.   If it sounds good to YOU, then it sounds good. Many people swear by biwiring the proacs.   Didn't work out for me, with my given cables.  Many people will also say that higher end single in will out do a mediocre biwire.   

Its amazing that an entry level high end pre like the LS -17 can sound so amazing, but with the dac 8, ds450, and the D48r, it's actually quite stunning.  I can't imagine how bonkers  a ref 5se would sound like to replace it.  Best part?  The sound at low volumes, completely satisfying with full projected images at proper size.  👏 
Try replacing the stock jumper bars with a jumper made from the Synergistic cable you are using, if you have not already done that. Replacing the bar with a jumper made from the same cable made a positive difference in my system.
+1 for Jperry's comment above - jumper bars are probably the worst thing to use - I always use speaker wire the same as the speaker cables.

If you have store bought cables then get some quality wire from a company like Van den Hul or DH Labs. They both use great quality copper

Regards...


Agree with Jperry as well. I replaced the jumper bars on my D-30R
with Clear Day Cables jumpers and the difference was noticeable.
Probably didn't hurt that I'm using Clear Day cables too.
Replaced replaced the jumper bars since day one.  My shop gave me 4 small scraps of proac cable to use.  Even from day one it was noticeable.  :-)