The overhang, which is fixed with the three hole mounting, is determined by the pivot to spindle distance. You have changed this distance if you have moved the position of the arm. With two hole mounting the play in the headshell will allow you to compensate by moving the cartridge in the headshell.
Rega P3 - Arm hole too small?
I have had my P3 for a while now and just change my cartridge. I now need a 4mm spacer and the regualr nut is no good so I had to get the extended nut. Problem is that the nut doesn't fit in the hole. I dremeled out the hole bigger but the hole is now slightly irregular. I only had to dremel the bottom half and not go near the top where the plinth is. Is this a problem at all? I'm thinking as long as the nut is tight I should be okay. Am I wrong?
Thanks,
Steve
Thanks,
Steve
- ...
- 6 posts total
- 6 posts total