Replacement pwr supply for Aragon 24k

Hi!
The power supply for my Aragon 24K Pre-amp just went out. You say there is a fuse? If so, where is it and how do you open the power box? Thank you for any assistance you can give me.
Penonome

@ Penonome: the screws are in the rubber thingies at the underside of the powersupply. Unscrew them and you can slide the triangular top of. Then you should see this (click link):

http://aycu06.webshots.com/image/29405/2001951001830719888_rs.jpg

The fuse is on the right. Good luck!

Thanks Satch!

I must have a very old Aragon 24k because the power box is not triangular and, after removing the rubber thingies on the underside there was nothing to unscrew. It is solid with no indication of a place to open it. I wonder if I have to pry open the box. The model number is ILDK-19 if that means anything.

Again, thanks for your kind help.
Penonome

Aha. I have the Aragon 24K with the IPS, the Improved Power Supply. This wasn't standard, you had to buy it separately. It was said to improve upon the standard powersupply, which you probably have. I have seen thatone in real life, so I can't tell you how to open it. But I'm sure there's a way to open it, and I'm also sure there's a fuse inside. There is an entire forum dedicated to Aragon gear, so you might ask your question there:
http://forums.klipsch.com/forums/20/ShowForum.aspx

Penonome you have the pwr supply I had repaired. Someone before I brought the unit cut the pwr supply around the middle and this is how my tech got into it. Once repaired he put some kind of epoxy around the cut to seal it. So far no problems. Hopes this helps.