Speaker jumpers on Tannoy System 12's

The woofers use most of the power coming in on the wire, so i would try wires on the woofers, with the jumpers to the tweeters/midrange-tweeters. Also, woofers are slower than mid/tweet.. so the tiny bit longer cable to mid/tweet helps this way, rather than subtracts. (this is theoretical in all but the very most hi end systems.. but every little bit helps.)

Thanks! Very helpful.

Try both ways and see if you can tell a difference,chances are you won't.

They are basically binding posts and they can be replaced, but you would need jumpers if you weren't bi wiring and/or need to adjust the tweeter. Remove the screws on the back plate (careful, the coil may be attached to the box separately). Remove the screws to the circuit board and below it are their binding posts. If you do replace them, shoot me a email. If you are reasonable I'll buy them from you.