2. amps-preamps
  3. 124023-6024

Upgrade path

I'm currently running a set of Dunlavy SC4 speakers bi amped into a Theata Dreadnaught 1 amp with the 5x200 watt set up, Preamp is a Audio Research ls3. Looking for opinions on what I should up grade 1st of the 3 pieces. I was thinking a bigger amp in the 400 watt range but one that would be an noticeable improvement over the Theat which to my ears does a lot of things right. Amp wise I would not be looking to spend more than 4K 
2channeljunkie
2channeljunkie OP
99 posts
 
tomcy6 you believe that 200watts is enough juice for the Dunlavy's?
tomcy6's avatar
tomcy6
1,368 posts
 

2channel,

Here are the specs for your speakers.

Sensitivity: 91dB/W/m. Impedance: nominal 5 ohms, minimum 3.0 ohms, maximum 7.5 ohms including bass resonance. Power handling: peak 250W for 10ms, average (pink noise) 25W. Recommended amplifier power: minimum 100W into 8 ohms.

With a high sensitivity, benign impedance curve and reviews stating that Theta doubles power to 400 wpc into 4 ohms, 200 watts should play them loud enough to drive you out of the room before clipping. Some people feel that you need a more powerful amp to properly control the bass cones. A more powerful amp may get you better bass, I don’t know, but a sub will definitely give you deeper bass and take some of the work from the Dunlavy’s bass cones allowing them to distort less.

There are a lot of nice amps out there and I’d bet you could find one that improves on your Theta. Maybe you should talk to the people at Theta and see if they can upgrade yours and what it would cost.



2channeljunkie OP
99 posts
 
Tomcy6, that's crazy I just spoke with Theta this afternoon. They said the exact same thing! The only recommendation they gave was to go with a set of mono block amps which would give more current. Of course they recommend Enterprise and Citidel monos. Said I should stay away from tubes as they would be mushy with the Dunlavy speaker said? Said Mac amps would be nice however a different sound. Also said while Krell would grip the bottom end I would lose a lot of midrange magic. One thing I've learned is the Theta takes a long time to warm up and now I keep in stand by mode. And must say the amp sounds great to me! May just look at a better preamp but I need one with 2 sets of main outputs so I can continue to bi amp with the Theta(which is the main reason I thought of replacing the Theta)
tomcy6's avatar
tomcy6
1,368 posts
 

2channel, Good luck with whatever direction your audio journey takes you.  There's certainly no shortage of options out there.

2channeljunkie OP
99 posts
 
Any thoughts on Mcintosh MC2500? Got a line on one that's been completely rebuilt
More to discover