2. amps-preamps
  3. 1149770039

Von scheikert VR4jr what are you using ?

I just got a new pair and I am wondering what amp would be best. I have a Cary SLP-98F1 as a pre and currently using a V12 to drive them. I have a BAT VK-200 as a spare and I am going to hook it up this week end, to see how it sounds with the SLP.
I originally heard the VR's driven by NuForce 9.02 mono's, they sounded fantastic. They were in a treated HT room, which is totally diferent than my space. Right now before break in they sound good but I get don't get close to the sound I heard in the demo room(of coarse I never do). I can only come out about 1 1/2 ft. from the front wall, so I'm pretty sure that is where I lose a lot of the spatiousness.
I am curious to see what other VR4jr owners are using and what they have heard elsewhere.
jdodmead
pardales
652 posts
 
No doubt about that, Tvad. I may be just a little crazier than the next guy about this hobby, and trying stuff out. ;)
mfsoa
76 posts
 
Blindjim,
Thanks for your reply. I tried an experiment tonight, just hooking up cables to the upper pair on the woofer module - No sound.
I don't think that you are doing anything by hooking up cables to these posts. They're just not connected to any drivers, I believe.
Can someone please prove me right or wrong?
BTW, I walked into my room tonight to find one of my M/T modules on the floor! Only minor damage - Must have been my dog tangled in the cables. BooHoo
mr_dingo
18 posts
 
Hello!

Nobody who has try Moon or Krell on Jr´s

regards

Dingo
jdodmead OP
241 posts
 
Just to update on what I am doing. I bought a pair of used Nuforce 8.02's. They are awfully small amps,but put out a lot of power and tight bass. Haven't decided yet if I'm going to keep them, it's a toss up between these and my 80 lb V12. They both sound great, just a little different.
blindjim
2,837 posts
 
mfsod

you may want to have your speakers checked out. the 3 pairs of binding posts are connected to the respective drivers. tops are for all the driveers in that module.... next down are for the mid bass... and bottom most are for the low end driver.... ensure the data lnik is removed. the brass plates are removed. don't connect anything to the speakers at that point, except which ever driver you wish to check out.... if when hooked from the amp to the driver, you get no sound... somethings up.... somewhere.... change to another driver... and so on.... trust me here... what I said does work. If it isn't on yours then you have an issue.... Hope things turn out OK
More to discover