Wyred STP-SE : Break In Times

Rpw,

I replaced all the steel chassis fasteners with those of musical brass. Between the actual transformer and the chassis I placed 3 Audiopoint .2's on 3 Audiopoint APCD2's all of brass. This was all tensioned and secured with a brass rod and locking hardware. I took care to mark on the transformer and the chassis as to their orientation so as to maintain the measured factory noise level the same. I replaced the only 2 Dale fixed resistor values that are always in the signal path with Z foils from Vishay. All simple stuff I always do the steel for brass replacement for all my components and all my transformers are direct coupled as described with .2's Audiopoints or larger. Tom

Clearly you want to remove all the steel fasteners and replace with brass... Tom

Don't you sell the Audiopoint products audiotweak?

If so, wouldn't that disclosure be relevant?

Wc65Mustang/Audiofeil you are correct..and who are you today? I do sell what I believe in and use all the time. Can't imagine mounting a transformer on bowling balls or even bearings. I also buy brass fasteners from the local supply chain to use in my system and acoustic resonance control devices.Not the big box store but local hardware retailers.. Also use brass and resonance grounding and tuning methods in patented devices for musical instruments.

Tom.. seller of Audiopoints and purveyor of resonance grounding methods and acoustic coupling. That's me..

If in fact you are selling products and recommending them in the forums, perhaps your membership status should be changed from private to commercial.

Or you could continue advertising without disclosure as you've been doing.