XLR cable with RCA output


Hi folks, could any of you tell me if this will work: I would like to use a Straight Wire Crescendo XLR interconnect with the unbalanced output of my CAT SL 1 Signature, using an adapter plug. The power amplifier has XLR inputs that I'm also using. So configuration is: unbalanced output from the CAT --> adapter plug --> XLR Straight Wire interconnects --> to the balanced inputs of power amplifier. Would this give a tremendous deterioration of sound quality? Thank you in advance.

Chris
dazzdax
Purist Audio also makes the adapters and if you can locate them Infinity Audio makes a nice set too.

In my case I just had my cable reterminated. In hindsight that probably wasn't too wise as there is not much of a market when selling these cables.
Rowland research used to do that configuration too. Anyway, there is no advantage to XLR unless you do it straight balanced.
Like many others, I'm also using the cardas adapters between amp and pre-amp. In my case, it's modwright swl9.0 se pre --> cardas adapters --> acoustic zen matrix ii interconnects --> nuforce ref 9 v2 se amps.

The cardas product is very good in my setup. I retained the big soundstage I was used to hearing, and didn't have to re-terminate the interconnects (which provides downstream flexibility).

-Sam
Hi, I tried the XLR interconnects with a home brewed RCA to XLR adapter but I got no sound. The signal goes this way: CAT Signature RCA output --> RCA to XLR adapter --> XLR Straight Wire interconnect --> XLR input power amplifier. No sound.

Chris