Turntable stand, steel, aluminum,shelves of ?

Ken -
I have my 350 lb Walker TT sitting on a Walker Prologue Shelf which is sitting on a DIY rack Made from 18 x 24 x 1 1/2 rock maple and threaded brass rods, washers, and nuts. The bottom of the rack is outfitted with custom machined Walker Valid Points on Walker Resonance Discs. The rack is bolted at two points to the wall studs, with two 9000 lb rated jack posts in the basement under the joists that the rack feet are over. Very satisfying, and rock solid.

Slipknot1,

It seems as though you've made preparations to listen to vinyl durring an earthquake. Ain't overkill great!

What do you feel that having the Walker on the massive maple platform atop the rack does for the sound as compared to having it on any other type of platform, and had you tried it on another substrate.

regards,Ken

The platform is a 3 inch thick rock maple laminate designed and built by Lloyd Walker for the Proscenium Turntable. I failed to mention in my previous post that the Prologue Shelf sits atop 16 sorbothane pads (each one about 4" square). These too are supplied by Lloyd. Most of his turntable installations are set up this way, and I decided "if it ain't broke, don't fix it 'til it is"

As for other materials; with previous vinyl set ups I experimented with a variety of different materials including large slabs of granite and marble. I found them to ring like a bell, which can't be good for LP playback. I also experimented with different types of woods like, Beech, Baltic Birch and Maple. Each of these I tried with Tip-toes, cork/rubber footers, brass cones. The most satisfying combo I had prior to the Walker was a VPI Scoutmaster sitting on a 2 inch maple slab with brass cones under it. This was on the same rack I am using now without the wall anchors and jack posts.

I use a Sound Anchors turntable stand for my Galibier Gavia table. The stand is made of welded steel filled with sand and PVC damping tubes. It is firmly spiked into the flooring with steel spikes. The table does not have any suspension and it rests directly on a plinth that in turn rests directly on the Sound Anchors stand. I'm not sure of the total weight of the table and motor assembly, but it's roughly about 100 lbs.

The plinth is presently 2 maple butcherblock boards resting on top of each other, not glued or otherwise attached to each other. Each of the 2 boards is 3/4" thick.

I have tried a number of other plinths including granite (damped and undamped), 3" maple butcherblock, mdf, Baltic Birch/mdf composite, and maple/aluminum/maple composite. I'm sure I've left some out. Each material has a distinct sound quality. Most have positives and negatives. My favorite (or the least objectionable) is the present setup of just 2 maple boards resting on each other.

The whole assembly is very rigid and stable. The Sound Anchors stand has room for components to be placed on two levels below the table. Unfortunately, I have found that anything placed on these steel supports affects the sound of the turntable adversely. Hence, the stand is now a dedicated turntable stand.

I have a separate oak stand with a 3" granite surface plate on top, that is immediately next to the turntable stand. This turns out to be the ideal spot for the battery that powers the Galibier turntable motor. The sound of the vinyl setup changes rather markedly when the battery is moved to different surfaces. It sounds best on top of the granite. So my battery now has its own dedicated stand, strange as that may seem.

Dave