Single-wire spades from amp to biwire spkr posts?

Thanks for that Sfar. I may look into that with my Cardas GR.

If you like your Cardas cables, before buying anything else, you should try a high quality (like Cardas) set of jumpers on the speakers. Run the speaker cables to the MF/HF posts on your speakers, and then jump to the LF posts(or try it both ways and do what sounds best). Instead of stacking the spades, you might try finding jumpers with spades on one end and bananas on the other. That way you can attach the bananas to the posts with the main (spade terminated) speaker wires. If your jumpers have spades on both ends, try some Cardas bananas connected to the spade on one end of the jumpers and plugged into the post with the spade termination. BTW, if you decide to purchase something, there are many internally (and externally) bi-wired cables that terminate with a single set of spades at the amp end (as others have said above). Do a search under cables - speaker, here on Audiogon.

Another option would be for you to construct your own jumpers. It is easy to make a set of jumpers that should perform just fine, and since the length is generally a foot or less, the effect of that wire IMO is about nil, assuming the wire you use is of sufficient gauge (12-14 awg should be fine for the short run) and at least as good as the internal hook-up wire inside the speaker. You can order single crystal copper hook-up wire from Partsconnexion, VH Audio or others, or even actual speaker cable by the foot, and make up your own high quality set of jumpers using spades at one end and bananas at the other. If you are not comfortable with soldering, there are several really good spade and banana models that have compression terminations using set screws. I have Furutech spades with compression terminations, and I believe the highly rated Bocchino Audio connectors also use that method of termination (see the CRL website). If you are using copper wire, some cover the connection using Q-dope, silicon, or other compounds to resist exposure to air and potential corrosion. Many would think using high quality heat shrink over the connected part of the spade should be fine. You will need 4 spades, 4 bananas, 4 feet of wire or cable, and some heat shrink.

Mitch--thanks for all that info! I do have the Cardas jumpers,
so I'll try those. I know that there are several discussions here about how to orient the jumpers, and with my former Von Schwiekert speakers I had better results with the stacked spades on the LF terminal, contrary to most things I've read (clearer, less foggy bass; highs were fine and liquid with that nice VSR Revelator tweeter). The problem is I have a long run of speaker cable (> 20 feet), so new cables are expensive, and my Cardas are well broken in (I've had them for several years, and I bought them new) and I hate to let them go. I'll take a big loss if I sell them. So I'll see what I hear with the jumpers. Thanks again to Mitch and everyone else who chimed in here.

Good luck with your trial. If you like the sound but do not like stacking spades, I would bet Cardas would be happy to reterminate one end of your jumpers with bananas.