Looking for unbalanced I/C suggestions. My current system: B&K ST-1400II amp Quicksilver tubed linestage Sony CE775 SACD MSB Link DAC Magnepan MG-12
I'm currently using Kimber PBJ I/C's and 8TC speaker wires. The system currently has too much high end detail and not enough warmth. I think the PBJ's are the culprit (I doubt it's the electronics).
Looking for an I/C that will impart a touch of warmth/lushness. My budget is @ $100 per cable (new or used).
to Audioengr: I too am using a pair of Kimber IC's at the present, and find the top end a little bit too much...would you mind elaborating on the mods you suggest?
Canare Starquad mic cable. Cheap, quiet, and linear. I'm using it on a pair of Earthworks mics on my Steinway B into an Alesis Masterlink into my Aleph P into my System in the same room, and I'll be damned if sometimes my Parsifal Encores (which flank the B) sound BETTER than ME live! Course part of that's the spaciousness offered by the 27" "berklee pair" micing technique, I s'pose.
Check out Phoenix Gold ZeroPoint Pro,teflon dielectric,70 fine strand cast mirror finish FP copper twisted pair balanced,triple shielded,directional drain grounded about 60 dollars 1 meter(1/2m available as well)if shielding is not wanted you can remove it,the materials are quite nice at this price.IMHO
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.