Run Balanced and RCA at the same time?

Hello RWD:

The RS1x crossover box is required for the proper operation of the mid/tweeter panels. The xover in the bottom of the panels IS NOT FULLY PASSIVE. You MAY damage your mid/tweeter panels running direct. For your info, please check this PDF I put up for you at my site:

http://www.tiac.net/users/ltm/RS_I_technical_sheet.pdf

It clearly shows caps in the line to the hi-pass outs.
EMIM mylars are no longer available, I'd hate to see you ruin a fine speaker. Lord knows, I must have owned and tweaked 5 pairs of RS1x over the years! Please RWD, proceed with extreme caution!

beemer

Since we are on the subject, i just saw a review of a product that had LESS gain through the balanced outs than it did through the RCA's. I think it was appr +4 dB's hotter through the RCA's, so this was really confusing and out of the ordinary. Should you have questions about stuff like that or have to use both types of outputs, i would HIGHLY recommend contacting the manufacturer.

RWD, Beemer is quite right. Treat your babies with respect and proceed with the utmost in caution. Parts for that speaker don't grow on trees anymore. Sean
>

Thanks Sean & Beemer....before I run my VT 100 amp into the mid/tweeter panels directly I will add the cap (not sure where((I am a techno dummy)). I will have my dealer do it. But some people say put the cap in the vt 100....some say add an out-cable box with the cap in it.....some say put the cap in the ls 25 pre amp. What are your thoughts?