definition of balanced mode vs. single ended

Four conductors (counting the shield and ground) -- isn't that the same as what Dgarretson said? It's true that not all 5 pins on the connector are used.

Great explanations of balanced from dgarretson and shadorne.

As I was reading a article in a audio magazine what was described as being balanced was that both speakers would have equal sound and as where single ended sometimes is unbalanced meaning one speaker is louder than the other. Would anybody like to comment on this?

I suppose it's possible to carry two balanced channels on a single 5-pin connector, but in audio one usually finds an XLR connector with three pins (hot, cold, ground) plus the barrel. The barrel can be connected to a shield or directly to the ground pin, but typically the barrel is left floating. BTW, I would doubt that a balanced cable makes much difference (even on long runs) when attached to a component that isn't full-balanced. Such components often add a phase-inverter to derive a balanced output. The additional electronics at the balanced output may degrade the sound relative to the RCA outputs. An external XLR/RCA converter plug uses just the hot/ground pins of the XLR junction to derive a single-ended signal for the RCA, discarding the inverted signal on the cold/ground pin side. In this scenario, half the circuitry in your expensive full-balanced component goes to waste.

There is convenience for both applications as well. Most all home audio that uses balanced connections will sound better than when using single-ended, because that is how the equipment was designed.

Pro audio is benefitted greatly by balanced cables because of length of run, and because of the fact that you can connect multiple lines together to get the lenght you need, simply because of the connector style.

All balanced connections I've ever seen have three pins.