Wire the House A/C or get Power Conditioner?

Keep the runs separated by about six inches, over their total length, to avoid any induction.

Wire off of the truck is fine . Just make sure that it is copper , not aluminum .

Your electrician will be happier with 12g. wire than 10g. when it comes time to make the connections at the recepticles !

Another consideration , that I like , is to have the new circuits installed with an 'isolated ground'. This will make sure that you do not get any noise/interference from anything else in your house . This is how hospitals and computer rooms do their sensitive stuff . While it is not difficult it is different and will probably require the services of a commercial electrician rather that a residential one . Just google isolated ground systems and get a rudimentry knowledge of it so that you know what you are getting . As I said , it is not difficult .

This way should be cheaper and longer lasting than a conditioner . As above , you can go to any extreme that your wallet will allow !

Good luck.

I bought a brand new, American made, 250' spool of 10/2 Romex off eBay, for $75.00(shipped). That was about one third the price locally. It's YOUR aural satisfaction that's important, not your electrician's happiness! Use 10 AWG for your dedicated runs.

Agree you should use 10ga wire, and yes some electricians may grumble a bit.

As to installing isolated ground circuits and receptacles, I've become convinced that in residential construction with wood stud walls, or solid masonry, isolated grounds do not add any benefit.

Isolated grounds are used in commercial construction because of the metal studs in all the walls makes the entire structure one big grounding grid with lots of potential for adding multiple ground loops and noise.

This is simply not an issue with outlet boxes nailed to wood studs. In the residential construction setting, the single home run pull of cable back to the circuit panel makes for a single "isolated" ground wire connection. (But if your walls are built with metal studs, by all means use an isolated ground wiring installation and receptacles.)
.

Power conditioner first;the amount of money involved will be far less than dedicated lines. If whatever problem you think you have is still audible, take the next step. I think it is odd not so long ago "ultra" cables,cleanpower,outlets,power cords, etc. were never a concern. Input, amplification, speakers were it. Once the basics are covered, someone somewhere will tell you about a problem you didn't know you had and offer a solution to your newly revealed system flaw. Spend as much as you want, convince yourself that it makes an audible improvement. Good Luck. I'm spending my money on music.