2. amps-preamps
  3. 1296699413

2ch amp and HT receiver connected to same speakers

I listen to 95% music and 5% home theater. My 2ch system is a BAT pre and a Bryston amp, and I have an Integra receiver for theater. My BAT has a HT pass-through function, so that I can run my LR speakers off my Bryston amp. This setup causes a ground loop, however, and I've given up trying to eliminate it. So I wonder if I can connect both my 2ch amp and the LR outputs of my receiver to my speakers. Would this harm my amp (especially the Bryston)? Would it hurt the sound quality of my music? Thanks for any comments.
slanski62

Showing 3 responses by tls49

tls49's avatar
tls49
1,318 posts
 
What have you done to eliminate the ground loop?
tls49's avatar
tls49
1,318 posts
 
I'm still thinking to solve the ground loop. I've helped lots of buddies hook up using HT bypass, or just taking front preouts to an input on the preamp, then always setting it's volume control to the same position. It's hard for me to believe the ground loop cannot be solved.
tls49's avatar
tls49
1,318 posts
 
Good answer Swampwalker, this is the problem many times. Of course, the simple test is to have everything hooked up using the HT bypass, but with the incoming CATV from the wall disconnected from the system. If the hum is gone, an isolation transformer will solve the problem. A simple, inexpensive cure to the problem.
More to discover